Meanwell power supply¶
A market sourced solution for installing by a certified electrical installer.
Maximum number of motors: 5.
This power supply is rated 15 volts, but can be increased to 18 volts by adjusting the small set-screw.
Adjusting voltage to 18volts by turning the set screw to the right.
Datasheet: meanwell DR-100-15
Check here for wiring information.
To connect a open ended wire to a Powerview® motor use the following connector:
- Outside diameter : 5.5mm.
- Pin diameter: 2.1mm.
- Article no.: 17.0361.0000
document version: 1.0 | generated: 2021-03-05 00:13:14