Skip to content

Meanwell power supply

dr-100-15

A market sourced solution for installing by a certified electrical installer.

Maximum number of motors: 5.

This power supply is rated 15 volts, but can be increased to 18 volts by adjusting the small set-screw.

set screwAdjusting voltage to 18volts by turning the set screw to the right.

Datasheet: meanwell DR-100-15

Check here for wiring information.

To connect a open ended wire to a Powerview® motor use the following connector:

barrel

  • Outside diameter : 5.5mm.
  • Pin diameter: 2.1mm.
  • Article no.: 17.0361.0000

document version: 1.0 | generated: 2019-05-20 01:56:25